Installation Guide

2
INSTALLATION INSTRUCTIONS
239-Indoor Wall Sconce
WS-23932
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
FIG. 2 Wiring
FIG. 1
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous impro
vement program. Jan 2019
JANUARY, 2017
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture,
including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a clear
area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (D) and back plate from the fixture.
4. Secure the mounting back plate to the junction box using the
screws provided with the junction box.
CONNECTING THE WIRES (Fig. 2)
5. Connect the driver's input wires to the junction boxes as shown (Fig. 2). Make sure that all wire
connectors (A) are secure. If your outlet box has a green or bare copper ground wire, connect the
fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the back plate
using the green screw provided. After wires are connected, tuck them carefully inside the junction
box.
6. Secure the fixture to the mounting back plate using the mounting screw (D) .
7. Thread the crystal glass into the lamp body, and then lock it with Allen screw (C) using Allen wench
(B).
DIMMING WIRING INSTRUCTIONS (Fig. 3)
9. To utilize ELV or TRAIC dimming: use black (hot), white (neutral) and bare copper ground wires (ground).
10. To utilize 0-10V dimming: use purple (dim+), gray (dim-), black (hot), white (neutral) and bare copper ground wires (ground).
NOTE: Make sure to connect 0-10V prior to powering up the fixture in order to allow the 0-10V dimming to function properly.
Back Plate Dimensions
Driver
4"L x 4"W x 5/8"H
Mounting
Screw
Junction
Box Screw
Mounting Plate
Junction Box
C
Wire Connector
Crystal
(RPL-GLA-23932)
Allen Wrench
Allen
Screw
A
A
C
B
D
1 3/8"
1 3/4"
Ø6"
FIG. 3
White - Neutral
Black - Hot
Purple - Dim+
Gray - Dim-
Red - Fixture+
Black - Fixture-
NOTE: The side of the mounting plate marked "GND" must face out.
NOTE:
This fixture features electronic low voltage (ELV or TRAIC) or 0-10V dimming capabilities.
See notes below for specific dimming wiring information.
COMPLETING THE INSTALLATION