Installation Sheet

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. 3
MOUNT ON 4”X4” JUNCTION BOX (Fig. 2)
3. Remove the mounting screw (C) from the xture, and then take down the mounting back plate.
4. Connect the Driver (F) input wires to junction box wires as shown in Fig. 3, making sure that all wire connectors (A) are se-
cured. If your outlet box has a green and bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect
the xture’ ground wire directly to back plate using the green screw provided.
* Requires Driver to be recessed in the switch box.
5. Secure the mounting ring (D) to the junction box using junction box screws (B).The side of the mounting ring marked “GND”
must face out.
6. Secure the mounting back plate and conversion plate (E) to the mounting ring with the junction box screws (B).
7. Connect the xture’s wires to the driver’s output wires with the male end connector and female end connector.
8. Secure the xture to the mounting back plate using the mounting screw (C).
INSTALLATION INSTRUCTION
148– LED Wall Sconce
WS-14818/WS-14824/WS-14836
G0
Fig.1 Mount on Junction Box
E
F
D
B
B
Junction Box Screw
Junction Box Screw
Mounting Ring
Driver 2 7/8”[L]x1 3/8”[W]x1 1/8”[H]
Junction Box
Conversion Plate
Mounting Plate
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 3 Wiring