Installation Sheet

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. 2
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for
installation.
MOUNT ON 2”X4” SWITCH BOX (Fig. 1)
3. Remove the mounting screw (C) from the xture, and then take down the mounting back plate.
4. Connect the Driver (F) input wires (F) to switch box wires as shown in Fig. 3, making sure that all wire connectors (A) are
secured. If your outlet box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect
the xture’s ground wire directly to the back plate using the green screw provided. After wires are connected, tuck them
carefully inside the switch box.
* Requires Driver to be recessed in the switch box.
5. Secure the mounting ring to the switch box using junction box screws (B).The side of the mounting back plate marked “GND”
must face out.
6. Connect the xture’s wires to the driver’s output wires with the male end connector and female end connector.
7. Secure the xture to the mounting back plate using the mounting screw (C).
OR
INSTALLATION INSTRUCTION
148– LED Wall Sconce
WS-14818/WS-14824/WS-14836
G0
Fig.1 Mount on Switch Box
A
C
F
D
B
Wire Connector
Ground Wire
Mounting Screw
Switch Box
Driver 2 7/8”[L]x1 3/8”[W]x1 1/8”[H]
Female/Male end Connector
Mounting Ring
Junction Box Screw
Mounting Plate
Fixture
d
k
a
φ4"
Back Plate Dimensions Mounting Ring Dimensions Conversion Plate Dimensions
7 1/8”
3/4”
1 5/8” 1 3/8”
1 3/4”
1 3/8”
9”
1 5/8”
1 3/8”
4 1/2”
Ø4”