Installation Sheet

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 2014
INSTALLATION INSTRUCTION
MUSE
WS-12118
PREPARATION
1. Shut o the power at the circuit
breaker and remove existing xture,
including the mounting hardware.
2. Carefully unpack your new xture
and lay out all the parts on a clear area.
Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Place the glass diuser (G1) onto the holder
(K1), secure it using the knurling nuts (D1).
4. Thread the wood tail (H1) onto the xture bottom (I1).
5. Secure the mounting bar (E1) to the junction
box (F1) using the junction box screws (B1). The
side of the mounting bar marked “GND” (E1)
must face out.
6. Adjust the nipple suitable length and secure using
the hex nut (J1).
CONNECTING THE WIRES (Fig. 2)
7. Connect the xture wires to supplier wires as shown in Fig. 2,
making sure that all wire connectors (A1) secured. Fixture and junction
box ground wires should be connected to mounting plate using green
screw provided. After wires are connected, tuck them carefully inside the
junction box.
8. Place the xture back plate (L1) over the mounting bar (E1)
and secure with the knurling nut (N1) tighten.
9. Put the shade (M1) onto the xture back plate (L1).
Secure with the mounting screw (C1) and the rubber washer (P1).
100%-10% DIMMING
COMPATIBLE WITH THE FOLLOWING ELECTRONIC
LOW VOLTAGE (ELV) DIMMERS
Brand Model
LUTRON SELV-300P
LUTRON DVELV-300P
LEVITON MLE03-1
F1
A1
J1
E1
B1
L1
N1
K1
D1
G1
C1
H1
P1
M1
FIG.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring