Installation Sheet

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 2014
INSTALLATION INSTRUCTION
Vermeil
WS-11311
100%10% DIMMING
COMPATIBLE WITH THE FOLLOWING ELECTRONIC
LOW VOLTAGE ELV DIMMERS
Brand Model
LUTRON SELV-300P
LUTRON DVELV-300P
LEVITON VPE04
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out the parts on a clear area. Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the screws (C1) from the xture.
4. Place the glass diuser (K1) onto the holder (J1), secure it using the nuts (I1) and rubber washers (W1).
5. Secure the mounting plate (E1) to the junction box (F1) using the junction box screws (A1).
The side of the mounting plate marked “GND” (E1) must face out.
CONNECTING THE WIRES (Fig. 2)
6. Connect the transformer input wire to supply wires as shown in Fig.2, making sure that all wire connectors (B1)
are secured. If your outlet box has a green or bare copper ground wire, connect the xture’s ground wire to it.
Otherwise, connect the xture’s ground wire directly to the back plate (E1) using the green screw provided.
After wires are connected, tuck them carefully inside the junction box.
*Requires Transformer (H1) to be recessed within the junction box
7. Place the xture back plate (L1) over the mounting plate (E1) and secure with screws (E1).
8. Put the shade (M1) into the clips on the xture back plate (L1).
B1
A1
E1
H1
F1
L1
M1
I1
W1
K1
J1
C1
FIG.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
H
ouse Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
Input
Output