Installation Sheet

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 2014
INSTALLATION INSTRUCTION
ARIES
WS-11218
PREPARATION
1. Shut o the power at the circuit breaker and
remove existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out all the parts
on a clear area. Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screws (C1) from the xture.
4. Secure the mounting plate (E1) to the
junction box (F1) using the junction box screws (B1).
The side of the mounting plate marked “GND” (E1)
must face out.
*Requires transformer to be recessed within
the junction box
CONNECTING THE WIRES (Fig. 2)
5. Connect the transformer input wires to supplier wires
as shown in Fig. 2. Making sure that all wire connectors
secured. If your outlet box has a green or bare copper
ground wire, connect the xture’s ground wire
to it. Otherwise, connect the xture’s ground wire
directly to the back plate (E1) using the green screw
provided. After wires are connected, tuck them
carefully inside the junction box.
6. Place the xture back plate (G1) over the mounting plate
(E1) and secure with the mounting screws (C1).
G1 C1
B1
E1
A1 D1
F1
FIG.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
InputOutput