Installation & Assembly

2
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company’s continuous improvement program.
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
3. Remove the mounting screw (C1) from the xture.
4. Secure the mounting back plate to the junction box using junction box screws (B1). The side of the mounting back plate marked “GND” must
face out.
CONNECTING THE WIRES (Fig. 2)
5. Connect the xture’s wires to junction box wires as shown in Fig. 2,
making sure that all wire connectors (A1) are secured. If your outlet
box has a green or bare copper ground wire, connect the xture’s
ground wire to it. Otherwise, connect the xture’s ground wire
directly to the back plate using the green screw provided. After wires
are connected, tuck them carefully inside the junction box.
COMPLETING THE INSTALLATION (Fig. 1)
6. Slide the glass into the front bracket; secure it with glass holder (E1)
using xture screw (D1).
7. Place the canopy plate over the mounting back plate; secure it with
the mounting screw (C1).
INSTALLATION INSTRUCTION
Vogue
WS-3127, WS-3127F, WS-3139, WS-3139F
FIG.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
WS-3127/WS-3127F Back Plate Dimensions WS-3139/WS-3139F Back Plate Dimensions
Junction Box
Ground Wire
M1
B1
Junction Box Screw
Mounting Screw
C1
D1
Fixture Screw
E1
Glass Holder
A1
Wire Connector
Mounting Backplate
Canopy Plate
Front Bracket
Glass
WS-3127/WS-3127F: (RPL-GLA-3115)
WS-3139/WS-3139F: (RPL-GLA-3120)
4 1/8”
1 3/4”
6 3/8”
1 3/8”
10 1/4”
1 3/8”
1 3/4”
4 1/8”