Installation & Assembly

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
246 - Pendant
PD-24610/PD-24614
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture,
including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area.
Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE Fig. 1
3. Remove the mounting screw (D1) from the xture.
4. Choose number of rods suitable for your application.
5. Thread the xture wire through the stems and canopy.
6. Connect the canopy, rod and xture body. Make sure all are tightened.
CONNECTING THE WIRES Fig. 2
7. Cut the extra wire. Connect the driver input wires with junction box wires
as shown in Fig.2, making sure that all wire connectors (A1) are secured.
If your outlet box has a green or bare copper ground wire, connect the
xture’s ground wire to it. Otherwise, connect the xture’s ground wire
directly to the mounting plate using the green screw provided. After wires
are connected, tuck them carefully inside the junction box.
*Requires Driver to be recessed within the junction box.
COMPLETING THE INSTALLATION Fig. 1, 3
8. Secure mounting plate to the junction box using junction box screws (C1).
The side of the mounting plate marked “GND” must face out.
9. Connect the driver output wire with xture as shown in Fig. 2, making
sure that all wire connectors (C1) are secured.
10. Place the xture over the mounting plate and secure with
mounting screws (D1).
11. Rotate the glass onto the lamp housing.
12. For slope ceiling application, rotate wire at the top of the stem to ensure
luminarie is aiming down (Fig.3).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
A1
B1
C1
D1
Wire Connector
Wire Connector
Junction Box Screw
Mounting Screw
Swivel
1 x 6” rod
3 x 12” rods
Rod
Lamp Housing
Glass
Driver
PD-24610 PD-24614
Driver
Canopy
Mounting Plate
Ground
Wire Screw
Ground Wire
Driver
Junction Box
Ø 4 3/4”
1 3/4”
1 1/4”
1 1/2” 1 1/2”
2 3/4”
3”
2”
1 3/4”
Ø 4 3/4”
FIG.1
Fig. 3
Turn to down
Back Plate Dimensions