Installation Sheet

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. 2
INSTALLATION INSTRUCTION
948-LED Pendant
PD-94860
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE Fig. 1
3. Remove the mounting screw (E) from the xture.
4. Drill holes in the wall aligned with the key holes located in the mounting back plate, insert the plastic anchor (D).
5. Secure mounting back plate to the junction box using junction box screws (B), fasten it to the wall using wood screw (C).The side of the
mounting plate marked “GND” must face out.
6. Adjust the xture wire length by pushing the cable gripper on the canopy and pulling the wire as desired.
CONNECTING THE WIRES (Fig. 2 )
7. Connect the driver input/output wires with junction box wires and xture as shown in Fig.2, making sure that all wire connectors (A) are
secured. If your outlet box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s
ground wire directly to the mounting plate using the green screw provided. After wires are connected, tuck them carefully inside the junc-
tion box.
8. Place the xture over the mounting back plate and secure it with mounting screws (E) .
Fig.1
Back Plate Dimensions
7MBC521001
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
13 3/4”
1 3/4”
11 3/4”
4”
1 3/8”
=
=
Cable-gripper
Push up
Driver
3 3/8”×2 7/16”×1 1/4”
Fixture
Mounting Plate
Junction Box Screw
Junction Box
Wire Connector
Plastic Anchor
Wood Screw
Mounting Screw
E
C
D
A
B