Installation Guide

Modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Ce
ntral Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Ave
Ontario, CA 91761
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. Mar 2019
INSTALLATION INSTRUCTIONS
929-LED PENDANT
PD-92927 / PD-92950
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (B) from the fixture.
4. Secure back plate to the junction box using the screws provided with the junction box.
NOTE: The side of the mounting plate marked “GND” must face out.
5. Choose number of rods suitable for your application. Thread the fixture wire through the rods, swivel and canopy,
connect swivel, rods and fixture body. Make sure all are tightened.
6. Thread acrylic tube C on the lamp body.
CONNECTING THE WIRES (Fig. 2)
7. Cut the extra wire. Connect the driver input wires with junction box wires as shown (Fig.3). Make sure that all wire
connectors (A) are secure. If your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire
to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate using the green screw provided. After
wires are connected, tuck them carefully inside the junction box.
8. Thread acrylic tube B on the fixture.
9. Thread acylic tube A and the etched acrylic on the fixture.
COMPLETING THE INSTALLATION
10. Secure the fixture to the mounting back plate using the mounting screws (B).
11. For slope ceiling application, rotate swivel at the top of the stem to ensure luminaries are aiming down (Fig.3).
NOTE: The fixture exceeds 28lbs, and must be installed using an outlet box UL
approved for up to 100lbs.
Fig. 3 Wiring