Installation Sheet
"#$%
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
&$'%"#%($%)#"*$+,-./
3. Remove the mounting screw (B) from the mounting plate.
4. Secure mounting back plate to the junction box using junction box screws. The side of the mounting plate marked “GND”must face out. Pull
out the driver output wire.
5. Unscrew the hexagonal nut inside of the canopy, take out the swivel.
6. Choose suitable rod for desired length.Thread the xture wire through the rods, swivel and canopy. Connect the canopy, swivel, rods and
xture. Make sure all are tightened, then screw up the swivel as before.
7. Hook the safety cord to the mounting plat to temporary hang the xture in place.
$%%"#%("#),-.0/
8. Connect the driver’s input wires to junction box wires, connect the drivre’s output wire to xture wire, making sure that all wire connectors
(A) are secured. If your outlet box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the
xture’s ground wire directly to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the
junction box.
9. Secure the xture to the mounting back plate using the mounting screw (B).
10. The lamp arm can rotate 190 degrees; rotate them to your desired angles.
%$"1#&&#%(##%(#%-$&"#$%,-.2/
11. This xture features electronic low voltage (ELV or TRAIC) or 0-10V dimming capabilities. See notes below for specic dimming wires
information.
12. To utilize ELV or TRAIC dimming: use wires black (hot), white (neutral) and bare copper ground wire (ground).
13. To utilize 0-10V dimming: use wire purple (dim+), gray (dim-), black (hot), white (neutral) and bare copper ground wire (ground).
-#(
-3
Black or
Smooth
-3
White or
Ribbed
-3
Bare wire
(Ground)
Black
(Hot)
White
(Neutral)
Green or Bare Copper
(Ground)
2
INSTALLATION INSTRUCTIONS
PD-81004
Phone (800) 526.2588
Fax (800) 526.2585
44 Harbor Park Drive
Port Washington, NY 11050
!
1600 Distribution Ct
Lithia Springs, GA 30122
1750 Archibald Avenue
Ontario, CA 91760
%
$
! "
#$%&
'%
(%
()&!*+,
! (%
! (%
"-
.$
/)&&