Installation Sheet

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
2WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
SUBLIME - LED Pendant
PD-93611
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the
parts on a clear area. Be careful not to lose any small
parts necessary for installation.
MOUNTING THE FIXTURE Fig. 1
3. Remove the mounting screw (C1) from the xture.
4. Thread the steel wire cord (D1) through the crystal, then
thread the two steel wire cord circle and the U bracket (E1)
through the xture wire. Hang the steel wire cord on the
xture as shown in Fig. 4.
5. Secure the U bracket to the xture with screw (F1).
6. Choose number of rods suitable for your application.
7. Thread the xture wire through the rods and canopy.
8. Connect the canopy, rods and xture body. Make sure
all are tightened.
CONNECTING THE WIRES Fig. 2
9. Cut the extra wire. Connect the driver input wires with
junction box wires as shown in Fig. 2, making sure that all
wire connectors (A1) are secured.
If your outlet box has a green or bare copper ground wire,
connect the xture’s ground wire to it. Otherwise, connect
the xture’s ground wire directly to the mounting plate
using the green screw provided. After wires are connected,
tuck them carefully inside the junction box.
*Requires Driver to be recessed within the junction box.
COMPLETING THE INSTALLATION (Fig. 1, 2, 3, 4)
10. Secure mounting plate to the junction box using junction
box screws (B1). The side of the mounting plate marked
“GND” must face out.
11. Connect the driver output wire with xture wire as shown in
Fig. 2 making sure that all wire connectors (A1) are secured.
12. Place the xture over the mounting plate and secure with
mounting screws (C1).
13. Rotate the glass onto the lamp housing.
14. For slope ceiling application, rotate wire at the top of the
stem to ensure luminarie is aiming down (Fig. 3).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring Fig. 3
Turn to down
Fig. 1
Fig. 4
Back Plate Dimensions
A1
B1
F1
E1
D1
C1
Wire Connector
Junction Box Screw
1 x 6” rod
Screw
U Bracket
Steel Wire Cord
Ground Wire
Junction Box
Driver
Mounting Backplate
Canopy
Mounting Screw
3 x 12” rods
Crystal Glass
1 3/8”
1 3/4”
Ø4 3/8”
INSTALLATION INSTRUCTION
SUBLIME - LED Pendant
PD-62711