Installation Sheet

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
PREPARATION
1. Shut o the power at the circuit breaker and remove existing
xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on
a clear area. Be careful not to lose any small parts necessary
for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screws (E1) from the xture.
Disconnect the Driver’s output wire. Remove the driver screw
(C1) and metal gasket (D1).
4. Secure mounting back plate to the junction box using
junction box screws (B1). The side of the mounting plate
marked “GND” must face out. Pull out the driver output wire.
5. Connect the driver input wires with supply wires as shown in
Fig. 2, making sure that all wire connectors (A1) are secured.
If your outlet box has a green or bare copper ground wire,
connect the xture’s ground wire to it. Otherwise, connect
the xture’s ground wire directly to the mounting plate using
the green screw provided. After wires are connected, tuck
them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1)
6. Choose the number of down rods suitable of your application.
7. Thread the xture wire through the rods, swivel and canopy.
Connect the canopy, swivel, rods and xture body. Make sure
all are tightened.
8. Connect the driver output wires with xture wire as shown in
Fig. 2, making sure that all wire connectors (A1) are secured.
secure the driver with driver screw (C1) and metal gasket (D1).
9. Place the xture over the mounting back plate and secure it
with mounting screws (E1).
10. For slope ceiling application, rotate swivel at the top of the
stem to ensure luminaries is aiming down (Fig. 3)
11. The lamp ring can rotate 350 degree; rotate them to your
desired angles.
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Fig. 3
Turn to down
FIG. 1
Back Plate Dimensions
INSTALLATION INSTRUCTION
Kinetic - LED Pendant
PD-61738
Ø 10"
1 3/8"
1 3/4"
Junction Box
Mounting Back Plate
Wire Connector
A1
Driver
Canopy
Mounting Screw
E1
Swivel
Rods
Fixture Faceplate
Metal
Gasket
D1
Driver
Screw
C1
Junction
Box Screw
B1
4x12” Rods
1x6” Rod
350°
350°
350°