Installation Sheet

Modern Forms
www.modernforms.com
$4;:1J-D
Headquarters/Eastern Distribution Center
->.;>$->7>5B1J$;>@+-?45:3@;:",
$4;:1J-D
Western Distribution Center
>/45.-80B1J#:@->5;
$4;:1J-D
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
INSTALLATION INSTRUCTION
Drift
PD-58756'
Mounting Screw
Qty: 4pcs + 1 Extra
7601010101
5/32-32x1/2
zinc plating
Washer
Qty: 4pcs + 1 Extra
13005011
zinc plating
Wood block
Qty: 1 Extra
19003127
CHANGING TO DECORATIVE WOOD CANOPY
ACCESSORIES
REMOVING THE FIXTURE AND METAL CANOPY









PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the mounting hardware.
2. Remove the wire nut and separate the wire. (shown #1)
3. Remove the Strain Relief (shown #2) and use washer to un-
screw hex nuts (shown #3)
4. Remove the cable and panel from the canopy assembly
5. Install the wire with the cable-gripper thru the decorative
wood panel
6. Secure the cable-gripper from the decorative wood panel
onto the canopy with washer and nut.
7. Install the mounting screw and washer to secure the canopy
with the decorative wood panel.
8. Wire the cable thru the strain relief (shown #4)
9. Connect the transformer input wires with supply wires
as shown in Fig. 2, making sure that all wire connectors
are secured.
10. Place the canopy over the mounting plate,
secure with mounting screws (E).
Cable-gripper
Strain Relief
Mounting
Screw
Washer
Canopy
Cable-gripper
Decorative
wood panel
Hex Nuts
Washer
Panel
Canopy
Wire Connector
Washer
Hex Nuts
E
PD-58738/58756/58784/58738F/58756F/58784F