Installation Sheet

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
577 - LED Pendant
PD-57718
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screws (C1) from the xture.
4. Thread the glass into the lamp shade inside.
5. Secure mounting back plate to the junction box using junction box screws (B1). The side of the mounting plate marked
“GND” must face out.
6. Disconnect the driver output wire connector (D1).
7. Adjust the xture wire length by pushing the cable grippers on the canopy and pulling the wires as desired.
CONNECTING THE WIRES (Fig. 2)
8. Connect the Driver input wires with junction box wires as shown in Fig. 2,
making sure that all wire connectors (A1) are secured. If your outlet box has
a green or bare copper ground wire, connect the xture’s ground wire to it.
Otherwise, connect the xture’s ground wire directly to the mounting plate
using the green screw provided. After wires are connected, tuck them
carefully inside the junction box.
9. Cut the extra wire, connect the Driver output wires with the xture wire
as shown in Fig. 2, making sure that all wire connectors (D1) are secured.
10. Place the xture over the mounting back plate and secure it with
mounting screws (C1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Wire Connector
Wire Connector
Back Plate Dimensions
Glass
Junction Box
Back Plate
Driver
Location Label
Junction Box Screw
Cable
Gripper
Lamp Shade
Location Label
A1
A1
B1
FIG. 1
Ø 5 3/8"
1 3/4"
1 3/8"