Installation Sheet

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
567 - LED Pendant
PD-56748
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove Remove the mounting screws (E1) from the xture.
4. Drill holes in the ceiling aligned with the key holes located in the mounting back plate, insert the plastic anchors (C1).
5. Secure mounting back plate to the junction box using junction box screws (B1), fasten it to the wall using wood screw (D1). The side of the
mounting plate marked “GND” must face out.
6. Adjust the xture wire length by pushing the cable gripper on the canopy and pulling the wire as desired.
CONNECTING THE WIRES (Fig. 2)
7. Connect the Transformer input wires with junction box wires as shown in
Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet
box has a green or bare copper ground wire, connect the xture’s ground wire
to it. Otherwise, connect the xture’s ground wire directly to the mounting
plate using the green screw provided. After wires are connected, tuck them
carefully inside the junction box.
8. Hook the safety cable to the mounting plate.
9. Place the xture over the mounting plate and secure it with mounting
screws (E1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Ø 7 7/8"
Ø 11 1/2"
1 3/8"
1 3/4"
Wire Connector
Junction Box Screw
Cable Gripper
Lamp Body
Glass
(RPL-GLA-56748-01)
Mounting Plate
Junction Box
Back Plate Dimensions
Plastic Anchor
Wood Screw
Mounting Screw
Transformer
Safety Cable
A1
B1
C1
D1
E1
FIG. 1