Installation Sheet

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
PREPARATION
1. Shut o the power at the circuit breaker and remove existing
xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on
a clear area. Be careful not to lose any small parts necessary
for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screw (C1) from the xture.
Disconnect the Driver’s output wire.
4. Connect the driver input wires with supply wires as shown in
Fig. 2, making sure that all wire connectors (A1) are secured.
If your outlet box has a green or bare copper ground wire,
connect the xture’s ground wire to it. Otherwise, connect
the xture’s ground wire directly to the mounting plate using
the green screw provided. After wires are connected, tuck
them carefully inside the junction box.
*Requires Driver to be recessed within the junction box.
MOUNTING THE FIXTURE (Fig. 1)
5. Secure mounting plate to the junction box using junction
box screws (B1). The side of the mounting plate marked
“GND” must face out. Pull out the driver output wire.
6. Choose the number of down rods suitable of your
application.
7. Thread the xture wire through the rods, swivel and canopy.
Connect the canopy, swivel, rods and xture body. Make sure
all are tightened.
8. Connect the driver output wires with xture wire as shown in
Fig. 2, making sure that all wire connectors ( A1) are secured.
9. Twist lock the glass diuser to xture shade.
10. Place the xture over the mounting plate and secure it with
mounting screws (C1).
11. For slope ceiling application, rotate swivel at the top of the
stem to ensure luminaries is aiming down (Fig. 3).
FIG. 1
Back Plate Dimensions
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
G
N
D
Knurling Nut
Junction Box Screw
Mounting Screw
Canopy
Rod
(RPL-ROD-IN06-WTA)
(RPL-ROD-IN12-WTA)
(RPL-ROD-IN06-BZ)
(RPL-ROD-IN12-BZ)
Fixture Shade
Glass Diuser
Output
Mounting Plate
Junction Box
Fixture Wire
Input
Drive
A1
B1
C1
Fig. 3
Turn to down
1/2"
4 1/2"
1 3/4"
1
3/8"
INSTALLATION INSTRUCTION
557 - LED Pendant
PD-55718, PD-55726