Installation Sheet

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
548-LED Pendant
PD-54868
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for
installation.
MOUNTING THE FIXTURES (Fig. 1)
3. Remove the mounting screw (E) from the xture.
4. Drill holes in the wall aligned with the key holes located in the mounting back plate, insert the plastic anchor (D).
5. Secure mounting back plate to the junction box using junction box screws (B), fasten it to the wall using wood screw (C).The side of
the mounting plate marked “GND” must face out.
6. Adjust the xture wire length by pushing the cable gripper on the
canopy and pulling the wire as desired.
CONNECTING THE WIRES (Fig. 2)
7. Connect the Power supply input wires with junction box wires as
shown in Fig.2, making sure that all wire connectors (A) are secured.
If your outlet box has a green or bare copper ground wire, connect
the xture’s ground wire to it. Otherwise, connect the xture’s
ground wire directly to the mounting plate using the green screw
provided. After wires are connected, tuck them carefully inside the
junction box.
8. Place the xture over the mounting back plate and secure it with
mounting screws (E) .
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
FIG. 1
A
B
CWood screw
Junction box screw
Wire connector
Plastic anchor
Back plate
Mounting screw
Canopy
Power Supply
7 1/4”L X 1 5/8”W X 1 3/16” H
Cable-gripper
Push up
Fixture
PD-54868 Back plate dimensions
23 5/8”
1 3/8”
1 3/4”
17 3/8”
4 1/4”
D
E