Installation Guide

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the
parts on a clear area. Be careful not to lose any small
parts necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screws (C1) from the xture.
4. Connect the driver input wires with supply wires as
shown in Fig. 2, making sure that all wire connectors
(A1) are secured. If your outlet box has a green or
bare copper ground wire, connect the xture’s ground
wire to it. Otherwise, connect the xture’s ground
wire directly to the mounting plate using the green
screw provided. After wires are connected, tuck them
carefully inside the junction box.
* Requires Driver to be recessed within
the junction box.
MOUNTING THE FIXTURES (Fig. 1)
5. Secure mounting back plate to the junction box using
junction box screws (B1). The side of the mounting
plate marked “GND” must face out. Pull out the driver
output wire.
6. Choose the number of down rods suitable of
your application.
7. Thread the xture wire through the rods and canopy.
Connect the canopy, down rod and xture body.
Make sure all are tightened.
8. Connect the driver output wires with xture wire as
shown in Fig. 2, making sure that all wire connectors
(A1) are secured.
9. Place the xture over the mounting back plate and
secure it with mounting screws (C1).
10. Adjust the connection tubes to your desired angle,
fasten it with Allen screws (E1) using Allen
wrench (D1).
11. Thread the glass into the lamp holder.
Wire Connector
Junction Box Screw
Mounting Screw
Allen Wrench
Allen Screw
Lamp
Holder
Connection
Tube
Lamp Body
Glass
(RPL-GLA-53728-01)
Canopy
Down Rod
Junction Box
Driver
Mounting Back Plate
A1
B1
C1
D1
E1
FIG. 1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
INSTALLATION INSTRUCTION
537 - LED Pendant
PD-53740
Ø 4 3/4"
Back Plate Dimensions
1 3/4"
1 3/8"