Installation Sheet

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the
parts on a clear area. Be careful not to lose any small
parts necessary for installation.
CONNECTING THE WIRES (Fig. 1)
3. Remove the mounting screws (C1) from the xture.
4. Secure the mounting plate to the junction box using
junction box screws (B1). The side of the mounting
plate marked “GND” must face out.
5. Adjust the xture wire length by pushing the cable
grippers on the canopy and pulling the wire as desired.
Make sure to keep the 3 xture wires the same length
and the whole xture is level.
6. Re-set the strain relief near the wiring holes.
MOUNTING THE FIXTURES (Fig. 2)
7. Connect the transformer input wires with supply
wires as shown in Fig. 2, making sure that all wire
connectors (A1) are secured. If your outlet box has a
ground wire, connect it to the xture’s ground wire.
Otherwise, connect the xture’s ground wire directly
to the mounting plate using the green screw provided.
Tuck wires carefully inside the junction box.
8. Place the canopy over the mounting plate. Twist it and
tighten the mounting screws (C1).
9. Twist lock the glass diuser into the shade.
Back Plate Dimensions
Mounting Screw
Ground Wire Screw
Ground Wire
Strain Relief
Canopy
Shade
Wire Connector
Junction Box Screw
Input
Transformer x3 (Output)
Glass
(RPL-GLA-52734-GL)
(RPL-GLA-52734-SL)
Glass Diuser
Supply Wire
Junction Box
Mounting Plate
Cable-gripper
Metal Ring
C1
A1
B1
FIG. 1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
INSTALLATION INSTRUCTION
527 - LED Pendant
PD-52734
8"
8"
4"