Installation Sheet

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
527 - LED Pendant
PD-52718/PD-52724
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the
parts on a clear area. Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE Fig. 1
3. Remove the mounting screw (C1) from the xture.
4. Secure the mounting plate to the junction box using
junction box screw (B1). The side of the mounting plate
marked “GND” must face out.
5. Adjust the xture wire length by pushing the cable
gripper on the canopy and pulling the wire as desired.
Make sure keeping 3 xture wires same length and whole
xture is level.
6. Re-set the strain relief near the wiring holes.
CONNECTING THE WIRES Fig. 2
7. Connect the transformer input wires with supply wires as
shown in Fig. 2, making sure that all wire connectors (A1)
are secured. If your outlet box has a ground wire, connect
it to the xture’s ground wire. Otherwise, connect the
xture’s ground wire directly to the mounting plate using
the green screw provided. Tuck wires carefully inside the
junction box.
8. Place the canopy over the mounting plate. Twist it and
tighten the mounting screws (C1).
9. Twist lock the glass diuse into the shade.
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
C1
A1
B1
Mounting Screw
Wire Connector
Junction Box Screw
Transformer (Output)
Junction Box
Supply Wire
Ground Wire
Ground Wire Screw
Mounting Plate
Input
Strain Relief
Canopy
Shade
Glass Diuser
Cable-Gripper
6”
6”
FIG.1
Back Plate Dimensions
G
N
D
3”