Installation Sheet

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 2014
INSTALLATION INSTRUCTION
Swing
PD-52512
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out the parts
on a clear area. Be careful not to lose any small parts
necessary for installation.
3. Thread the short stem (M1) onto the xture top (J1).
4. Choose the stem sections (M2) needed to hang the
pendant at desired height.
5. Connect the swivel (N1) on canopy (G1), stem sections (M2)
and the short stem (M1).
6. Lead xture wires through stem sections swivel (M2) and
canopy
7. Connect the xture wires to supplier wires as shown in
Fig. 2, making sure that all wire connectors (A1)
secured. Fixture and junction box ground wires should be
connected to mounting plate using green screw provided.
After wires are connected, tuck them carefully inside the
junction box.
8. Secure the mounting plate (D1) to the junction box (F1)
using the junction box screws (B1). The side of the mounting
plate marked “GND” must face out.
9. Place the xture back plate (G1) over the mounting
plate (D1) and secure with mounting screws (C1).
10. Put the glass (E1) onto the xture frame (J1). Secure
with Allen screws (I1) and Allen wrench (H1) provided.
100%-10% DIMMING
COMPATIBLE WITH THE FOLLOWING ELECTRONIC
LOW VOLTAGE (ELV) DIMMERS
Brand Model
LUTRON SELV-300P
LUTRON DVELV-300P
LEVITON MLE03-1
F1
A1
D1
B1
C1
G1
N1
M1
M2
E1
J1
I1
H1
FIG.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
Junction Box
Wire Connector
Mounting Plate
Mounting Screw
Mounting Screw
Canopy
Swivel
Short
Stem
Stem
Sections
Glass
Fixture
Frame
Allen
Screw
Allen
Wrench