Installation Sheet

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 2014
INSTALLATION INSTRUCTION
DAVOS
PD-51645
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out
all the parts on a clear area. Be careful not to lose
any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG.1)
3. Remove the mounting screws (H1) from the xture.
4. Drill holes in the ceiling aligned with the key hole
location in the mounting plate (D1).
5. Insert the mounting anchors (B1) into holes.
6. Secure the mounting plate (D1) to the junction box (F1) using
junction box screw (E1). The side of the mounting plate marked
“GND” must face out.
7. Fasten the wood screws (A1) through the mounting plate
into the mounting anchors (B1) and tighten.
8. Adjust the xture wire by pressing the cable-gripper (N1)
on the canopy and pulling the wire to desired length.
Make sure the wires are the same length.
9. Re-set the strain relief (I1) near the wiring holes.
10. Secure glass (K1) to the bottom of the xture
(J1)using spacers (L1) and screws (M1).
CONNECTING THE WIRES (FIG.2)
11. Connect the transformer input wires to supply wires as shown
in Fig. 2, making sure that all wire connectors (C1) are secured.
12. Cut the xture wires, leaving at least 6” for connections.
Connect with the transformer output wires (red).
Notes: The xture wires have two braided layers. Strip two
layers carefully!
If your outlet box has a ground wire, connect it to the xture’s
ground wire. Otherwise, connect the xture’s ground wire directly
to the mounting plate (D1) using the green screw provided.
Tuck wires carefully inside the junction box.
13. Place the canopy (G1) over the mounting plate (D1),
secure with screws (H1).
14. Check if xture is level and adjust cables if necessary.
F1
B1
C1
D1
E1
A1
I1
G1
H1
N1
J1
K1
L1
M1
FIG.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
Supply wire
Transformer
Input
Output
Fixture wire