Installation Sheet

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
497 - LED Pendant
PD-49712
PREPARATION
1. Shut o the power at the circuit breaker and remove existing
xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a
clear area. Be careful not to lose any small parts necessary for
installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screws (C1) from the xture.
Disconnect the Driver’s output wire.
4. Connect the driver input wires with supply wires as shown in
Fig. 2, making sure that all wire connectors (A1) are secured.
If your outlet box has a green or bare copper ground wire, connect
the xture’s ground wire to it. Otherwise, connect the xture’s
ground wire directly to the mounting plate using the green screw
provided. After wires are connected, tuck them carefully inside
the junction box.
*Requires Driver to be recessed within the junction box.
MOUNTING THE FIXTURE (Fig. 1)
5. Secure mounting back plate to the junction box using junction
box screws (B1). The side of the mounting plate marked
“GND” must face out. Pull out the driver output wire.
6. Insert the bracket with LED module into the glass shade.
Thread the xture wire through the cover and stem nut.
7. Place the cover on the top of the glass, secure the bracket and
cover with stem nut,
8. Choose the number of down rods suitable of your application.
9. Thread the xture wire through the rods, swivel and canopy.
Connect the canopy, swivel, rods and xture body. Make sure all
are tightened.
10. Connect the driver output wires with xture wire as shown in
Fig. 2, making sure that all wire connectors (A1) are secured.
11. Place the xture over the mounting back plate and secure it with
mounting screws (C1).
12. For slope ceiling application, rotate swivel at the top of the stem
to ensure luminaries is aiming down (Fig. 3)
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Fig. 3
Turn to down
Driver
Fixture Canopy
FIG. 1
Wire Connector
Junction Box Screw
Mounting Screw
Swivel
Stem Nut
Cover
Bracket
Glass
(RPL-GLA-49712-SM)
(RPL-GLA-49712-CA)
Back Plate Dimensions
Junction Box
Mounting Plate
A1
B1
C1
Ø 4 3/4"
1 3/4"
1 3/8"