Installation Sheet

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
467 - LED Pendant
PD-46745
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (E1) from the xture.
4. Drill holes in the ceiling aligned with the key holes located in the mounting back plate, insert the plastic anchors (E1).
5. Secure mounting back plate to the junction box using junction box screws (B1), fasten it to the wall using wood screws (D1). The side of the
mounting plate marked “GND” must face out.
6. Adjust the xture wire length by pushing the cable gripper on the canopy and pulling the wire as desired.
CONNECTING THE WIRES (Fig. 2)
7. Connect the Driver input wires with junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured.
If your outlet box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground
wire directly to the mounting plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
*Requires Driver to be recessed within the junction box.
8. Place the xture over the mounting back plate and secure it with mounting screws (C1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Plastic Anchor
Wood Screw
Mounting Screw
Cable Gripper
Mounting Plate
Back Plate Dimensions
Knurling Nut
Junction Box Screw
Wire Connector
White Wire
Driver
Black Wire
B1
A1
E1
D1
C1
FIG. 1
Ø 3 1/2"
Ø 2 3/4"
9 1/2"
7 1/4"
4 1/4"
1 3/4"