Installation Sheet

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
Quatrain - LED Pendant
PD-46724
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts
on a clear area. Be careful not to lose any small parts
necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screws (C1) from the xture.
4. Adjust the xture wire length by pushing the cable gripper
on the canopy and pulling the wire as desired.
5. Connect the driver input wires with junction box wires as
shown in Fig. 2, making sure that all wire connectors (A1)
are secured.
If your outlet box has a green or bare copper ground wire,
connect the xture’s ground wire to it. Otherwise, connect
the xture’s ground wire directly to the mounting plate
using the green screw provided. After wires are connected,
tuck them carefully inside the junction box.
*Requires Driver to be recessed within the junction box.
MOUNTING THE FIXTURES (Fig. 1)
6. Secure mounting plate to the junction box using junction
box screws (B1). The side of the mounting plate marked
“GND” must face out.
7. Place the xture over the mounting plate and secure it with
mounting screws (C1).
Wire Connector
White Wire
Black Wire
Driver
Mounting Plate
A1
FIG. 1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Junction Box Screw
Mounting Screw
Cable Gripper
Back Plate Dimensions
Junction Box
B1
C1
5 1/4"
1 3/4"
4 3/4"
1 3/8"