Installation Guide

2
INSTALLATION INSTRUCTIONS
459-Indoor Pendant
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
FIG. 2 Wiring
FIG. 1
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous impro
vement program. Feb 2019
ANUARY, 2017
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture,
including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a clear
area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the back plate screw (B) and back plate from the fixture.
4. Secure the back plate to the junction box using the screws
provided with the junction box.
NOTE: T
he side of the back plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
5. Choose suitable rod length for application, thread the fixture wire through the rods,
swivel and canopy. Connect the swivel, rods and fixture. Make sure all are tightened.
6. Connect the driver’s input wires and output wires as shown (Fig. 2). Make sure that all
wire connectors (A) and all wire connectors (C) are secure. If your outlet box has a
green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise,
connect the fixture’s ground wire directly to the back plate using the green screw
provided. After wires are connected, tuck them carefully inside the junction box.
NOTE: This fixture features electronic low voltage (ELV or TRAIC) or 0-10V dimming
capabilities. See notes below for specific dimming wiring information
Secure the fixture to the mounting back plate using the mounting screw (B).
DIMMING WIRING INSTRUCTIONS (Fig. 3)
8.
9
. To utilize ELV or TRAIC dimming: use black (hot), white (neutral) and bare copper ground wires (ground).
To utilize 0-10V dimming: use purple (dim+), gray (dim-), black (hot), white (neutral) and bare copper ground wires (ground).
NOTE: Make sure to connect 0-10V prior to powering up the fixture in order to allow the 0-10V dimming to function properly.
Wire Connector
A
Hexagonal Nut
Canopy
Monting Screw
B
Safety Cords
Junction Box Screw
Junction Box
Mounting Backplate
Driver
12" Rob
6" Rob
Swivel
Wire Connector
C
FIG. 3
White - Neutral
Black - Hot
Purple - Dim+
Gray - Dim-
Red - Fixture+
Black - Fixture-
Back Plate Dimensions
1 3/8"1 3/4"
∅5 1/2"
PD-45926/PD-45934
COMPLETING THE INSTALLATION
7.
Hook the safety cords to the mounting plate.
10 .