Installation Sheet

INSTALLATION INSTRUCTION
449- LED Pendant
PD-44918-T24/PD-44930-T24
PREPARATION
1. Shut off the power at the circuit breaker and remove
existing fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Be careful not to lose any small
parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (B) and back plate from
the fixture.
4. Adjust the fixture wire length by pushing the cable
gripper on the canopy and pulling the wire as desired.
a) Retract these wires close to a desirable length to
within the canopy before securing the fixture in
place.
Note: retracting or extending excessive cable
length through the cable gripper is not
recommended.
b) Warning: Shortening these cables without
professional helps or electronic background is not
advisable. Any modifications to the fixture may
result in voiding the warranty of the product.
5. Secure the mounting back plate to the junction box
using standard junction box screws that comes with the
junction box. Note: the side of the mounting plate
marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
6. Connect the driver’s input wires to junction box wires as
shown in Fig. 2, making sure that all wire connectors (A)
are secured. If your outlet box has a green or bare
copper ground wire, connect the fixture’s ground wire to
it. Otherwise, connect the fixture’s ground wire directly
to the back plate using the green screw provided. After
wires are connected, tuck them carefully inside the
junction box.
COMPLETING THE INSTALLATION
7. Secure the fi xture to the mounting back plate using the
mounting screw (B) .
NOTE: DIMMING WIRING INFORMATION (Fig. 3)
8. This fixture features electronic low voltage (ELV or
TRAIC) or 0-10V dimming capabilities. See notes below
for specific dimming wires information.
9. To utilize ELV or TRAIC dimming: use wires black (hot),
white (neutral) and bare copper ground wire (ground).
10. To utilize 0-10V dimming: use wire purple (dim+), gray
(dim-), black (hot), white (neutral) and bare copper
ground wire (ground).
Fig.2Wiring

Fixture Wires House Wires
Black or Black
Smooth (Hot)
Fixture Wires House Wires
White or White
Ribbed (Neutral)
Fixture Wires House Wires
Bare wire Green or Bare Copper
(Ground) (Ground)
Fig.1
Fig.3
Back Plate Dimensions
2
NOTE: Make sure to connect 0-10V prior to power-up the
fixtrure in order to allow the 0-10V dimmer to function
properly.
modernforms.com Headquarters/Eastern Distribution Center Central Distribution Center Western Distribution Center
Phone [phone] Harbor Park Drive 1600 Distribution Ct 1750 Archibald Avenue
Fax [phone] Port Washington, NY 11050 Lithia Springs, GA 30122 Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
Driver
Junction Box Screw
Mounting Screw
B
A
Wire Connector
Junction Box
C
anopy
Mounting Plate
Cable-gripper
Instruction: Adjust the fixture
wire length by pushing the
cable gripper on the canopy
and pulling the wire as desired.
Push up
Lamp Boby
RPL-GLA-44918
RPL-GLA-44930
1 3/8"
1 3/4"
∅5 1/2"
White - Neutral
Black - Hot
Purple - Dim+
Grdy - Dim-
Red - Fixtrue+
Black - Fixtrue-