Installation Sheet
2
INSTALLATION INSTRUCTION
PD-44267
Oct. 2021Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
Modern Forms.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
1. Shut o the power at the circuit breaker and remove
existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the
parts on a clear area. Be careful not to lose any small
parts necessary for installation.
3. Loosen the mounting screw (B) from the xture, and remove the mounting back plate.
4. Drill holes in the wall aligned with the key holes located on the mounting back plate. Insert the plastic anchor (D).
5. Secure the mounting back plate to the junction box using standard junction box screws that comes with the junction box.
Fasten the mounting back plate to the wall with the plastic anchors using the wood screws (C) provided.
Note: (i) Using any other non-original-manufacturer provided junction box screw may result in safety issue;
(ii) The side of the mounting plate marked “GND” must face out.
6. Adjust the xture wire length by pushing the cable gripper on the canopy and pulling the wire as desired.
a) Before securing the canopy in place, it is recommended to retract or extend the wire within the canopy to a desirable length.
b) Due to limited space within the canopy, shorten the cable as necessary to make the installation easier. Make sure to identify and
label all the wiring properly before any trimming/shortening (Fig. 3).
7. Connect the driver’s output wires to center cable as shown in Fig. 3, red to the center,
and black to the bare, make sure that wire connectors(A) are secured. Then tuck them inside the canopy.
8. Connect the driver’s input wires to junction box wires as shown in Fig. 2, make sure that all wire connectors(A) are secured.
If your outlet box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s
ground wire directly to the back plate using the screw provided. After wires are connected, tuck them carefully inside the junction box.
34 5/8"
5"
38 3/8"
1 3/4" 1 3/8"
Instruction:Adjust
the xture wire
length by pushing
the cable gripper on
the canopy and
pulling the wire as
desired.
B
Push up
Cable gripper
Suspending line
(MAX 120")
A
Junction Box Screw
Mounting back plate
Driver
Mounting Screw
Fixture
Canopy
Wire Connector
Junction box
Wood Screw
Plastic Anchor
Mounting back plate
Driver
D
C
White - Neutral
Black - Hot
Red +
Black -
Center +
Bare -
Driver(850mA)
White - Neutral
Black - Hot
Red +
Black -
Center +
Bare -
Driver(700mA)
Input
Output
Center - To Dr iver+( Red)
Bare - To Dr iver-(B lack)
Center - To Dr iver+( Red)
Bare - To Dr iver-(B lack)
Center - To Dr iver+( Red)
Bare - To Dr iver-(B lack)
Canopy
Label I
Input
Output