Installation Sheet

Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
Cascade - LED Pendant (9 Lights)
PD-41709R
PREPARATION
1. Shut o the power at the circuit breaker and remove existing
xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a
clear area. Be careful not to lose any small parts necessary for
installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screws (C1) from the xture.
4. Install the mounting back plate to the junction box using junction
box screws (B1)
5. Mark the three wood screw mounting holes on the ceiling, remove
mounting back plate, drill holes and insert the three plastic anchors
(E1)
6. Adjust the xture wire length by pushing the cable gripper
on the canopy and pulling the wire as desired. (see Fig. 3 for
recommended length)
7. Connect the driver input wires with supply wires as shown in Fig. 2,
making sure that all wire connectors (A1) are secured.
If your outlet box has a green or bare copper ground wire, connect
the xture’s ground wire to it. Otherwise, connect the xture’s
ground wire directly to the mounting plate using the green screw
provided. After wires are connected, tuck them carefully inside the
junction box.
MOUNTING THE FIXTURE (Fig. 1)
8. Install mounting plate back to the junction box using junction box
screws (B1), fasten it to the ceiling using the three wood screws
(D1). The side of the mounting plate marked “GND” must face out.
9. Push the xture onto the mounting back plate, and secure it with
mounting
screws (C1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
FIG. 1
Back Plate Dimensions
14 3/4"
3
1/2"
5
5/8"
Junction
Box Screw
Plastic Anchor
Wood Screw
Wire
Connector
Mounting Screw
Driver
Lamp Body
Crystal Glass
(RPL-GLA-41719)
Junction Box
Ground Wire
Mounting Back Plate
B1
E1
D1
A1
C1
Fig 3: Recommended length
44"
33"
54"
42"
48"
36"
47"
42"
42"
Cable
gripper
Push up
Instruction: Adjust the xture
wire length by pushing the
cable gripper on the canopy
and pulling the wire as desired.