Installation Sheet

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
PREPARATION
1. Shut o the power at the circuit breaker and remove existing
xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on
a clear area. Be careful not to lose any small parts necessary
for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screws (C1) from the xture.
4. Install the mounting back plate to the junction box
using junction box screws (B1)
5. Mark the three wood screw mounting holes on the ceiling,
remove mounting back plate, drill holes and insert the three
plastic anchors (E1)
6. Adjust the xture wire length by pushing the cable gripper
on the canopy and pulling the wire as desired. (see Fig. 3 for
recommended length)
7. Connect the driver input wires with supply wires as shown in
Fig. 2, making sure that all wire connectors (A1) are secured.
If your outlet box has a green or bare copper ground wire,
connect the xture’s ground wire to it. Otherwise, connect
the xture’s ground wire directly to the mounting plate
using the green screw provided. After wires are connected,
tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1)
8. Install mounting plate back to the junction box using junction
box screws (B1), fasten it to the ceiling using the three wood
screws (D1). The side of the mounting plate marked “GND”
must face out.
9. Push the xture onto the mounting back plate, and
secure it with mounting screws (C1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Junction Box Screw
Plastic Anchor
Wood Screw
Mounting Screw
Driver
Cable Gripper
Lamp Body
Crystal Glass
(RPL-GLA-41719)
Junction Box
Ground Wire
Wire Connector
Mounting Back Plate
B1
E1
D1
C1
A1
FIG. 1
INSTALLATION INSTRUCTION
417 - LED Pendant
PD-41703R
Back Plate Dimensions
8 7/8"
3 1/2"
1 5/8"
47"
39"
43"
Fig 3: Recommended length