Installation Sheet

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
356 - LED Pendant
PD-35615
FIG.1
Back Plate Dimensions
E1
A1
D1
C1
Plastic
Anchor
Wire
Connector
Wood
Screw
Mounting
Screw
Mounting
Backplate
B1
Juntion
Box Screw
Driver
Cable
Gripper
Cylinder
Lamp Body
Cylinder
Noodle Glass
Juntion Box
Ground Wire
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the
parts on a clear area. Be careful not to lose any small
parts necessary for installation.
CONNECTING THE WIRES Fig. 2
3. Remove the mounting screw (C1) from the xture.
4. Drill a hole in the ceiling aligned with the key hole
located in the mounting back plate, insert the
plastic anchor (E1).
5. Adjust the xture wire length by pushing the
cable gripper on the canopy and pulling the
wire as desired.
6. Connect the driver input wires with junction box
wires as shown in Fig. 2, making sure that all wire
connectors (A1) are secured. If your outlet box has
a green or bare copper ground wire, connect the
xture’s ground wire to it. Otherwise, connect the
xture’s ground wire directly to the mounting plate
using the green screw provided. After wires are
connected, tuck them carefully inside the
junction box.
*Require Driver to be recessed within the
junction box.
MOUNTING THE FIXTURE Fig. 1
7. Secure mounting plate to the junction box using
junction box screws (B1), fasten it to the wall using
the wood screw (D1). The side of the mounting plate
marked “GND” must face out.
8. Place the xture over the mounting plate and secure
it with mounting screws (C1).
9. Thread the noodle glass onto the lamp body.
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
20 3/4”
17 3/4”
1 3/8”
1 3/4”