Installation Guide

INSTALLATION INSTRUCTIONS
328 – LED Pendant
PD-32880
Fig. 1
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (C) from the fixture.
4. Drill holes in the wall aligned with the key holes located in the mounting back plate, insert the plastic anchor (E).
5. Secure mounting back plate to the junction box using junction box screws (B), fasten it to the wall using wood
screw (D).
6. Adjust the fixture wire length by pushing the cable-gripper on the canopy and pulling the wire as desired.
a. Retract the wires close to the desired length within the canopy before securing the fixture in place.
NOTE: Using the cable-gripper to adjust more than 18” of wire length is not recommended.
WARNING: Shortening the cables without professional help or electronic background is not advisable. Any
modifications to the fixture will result in voiding the warranty of the product.
CONNECTING THE WIRES (Fig. 2)
7. Connect the transformer input wires with junction box wires as shown (Fig.2). Make sure that all wire connectors
(A) are secure. If your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly to the mounting plate using the green screw provided. After wires
are connected, tuck them carefully inside the junction box.
8. Place the fixture over the mounting back plate and secure it with mounting screws (C) .
Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax (800)
526.2585
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. Jan 2019
2