Installation Sheet

2
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company’s continuous improvement program.
INSTALLATION INSTRUCTION
308 – LED Wall Sconce
PD-30826
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES Fig. 2
3. Remove the mounting screw (E) from the mounting back plate.
4. Drill holes in the wall aligned with the key holes located in the mounting back plate, insert the plastic anchors (B).
5. Choose suitable rod for desired length. Thread the xture wire through the rods, swivel and canopy. Connect the canopy, swivel, rods and
xture. Make sure all are tightened.
6. Connect the driver input wires and output wires as shown in Fig. 2, making sure that all wire connectors (A) are secured. If your outlet box
has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
mounting plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1 )
7. Secure mounting back plate to the junction box using junction box screws (C). Fasten it to the ceiling using the wood screws (D).The side of
the mounting plate marked “GND” must face out. Pull out the driver output wire.
8. Hook the two safety cords to the mounting plate.
9. Secure the xture onto mounting back plate with mounting screw (E).
10. Insert the crystal into the xture; secure it with Allen screw (G) using Allen wrench (F) and make sure it is unshakeable.
Fig.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Wire Connector
Plastic Anchor
Junction Box Screw
Wood Screw
Mounting Screw
Allen Screw
Allen Wrench
Driver
Crystal
3 3/8” L x 2 3/8” W x 1 1/8”H
(RPL-GLA-30815
Safety Cords
Canopy
12” Rod 12” Rod12” Rod 12” Rod
6” Rod
10 3/4”
1 3/4”
1 3/8”
10 3/4”
Nut
Mounting Backplate
Junction Box
PD-30826
Mounting Backplate
7MBC272712
A
B
C
D
E
G
F
G0