Installation Sheet

2
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company’s continuous improvement program.
INSTALLATION INSTRUCTION
208-LED Pendant
PD-24824/PD-24836
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the
parts on a clear area. Be careful not to lose any small
parts necessary for installation.
MOUNTING THE FIXTURES (Fig. 1)
3. Remove the mounting screw (C) from the xture.
4. Drill holes in the wall aligned with the key holes
located in the mounting back plate, insert the plastic
anchor (D).
5. Secure back plate to the junction box using junction
box screws (B), fasten it to the wall using wood screw
(E).The side of the mounting plate marked “GND”
must face out.
6. Adjust the xture wire length by pushing the cable
gripper on the canopy and pulling the wire as
desired.
CONNECTING THE WIRES (Fig. 2)
7. Connect the driver input wires with junction box
wires as shown in Fig.2, making sure that all wire
connectors (A) are secured. If your outlet box has
a green or bare copper ground wire, connect the
xture’s ground wire to it. Otherwise, connect the
xture’s ground wire directly to the mounting plate
using the green screw provided. After wires are
connected, tuck them carefully inside the junction
box.
8. Place the xture over the back plate and secure it
with mounting screws (C).
9. After installed ,adjust the outer ring
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
FIG. 1
BACK PLATE DIMENSIONS
G0
Junction Box
Wire Connector
Ground Wire
Plastic Anchor
Junction Box Screw
Wood Screw
Mounting Screw
Back Plate
Driver
3 1/2”LX2 3/8”WX1 1/4”H
Cable-gripper
Push Up
8
7
8
"
3
1
2
"
1
1
2
"
8 7/8”
1 1/2”
3 1/2”
A
D
B
E
C