Assembly Instructions

Modernforms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modernforms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MAY, 2014
INSTALLATION INSTRUCTION
Palladian
WS-11310
100%10% DIMMING
COMPATIBLE WITH THE FOLLOWING ELECTRONIC
LOW VOLTAGE ELV DIMMERS
Brand Model
LUTRON SELV-300P
LUTRON DVELV-300P
LEVITON VPE04
FIG.2
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare Copper
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
PREPARATION
1. Shut o the power at the circuit breaker
and remove existing xture, including
the mounting hardware.
2. Carefully unpack your new xture and
lay out the parts on a clear area.
Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the screws (C1) from the xture.
4. Hold the crystal (D1), crystal (G1)
onto the xture back plate (L1)
using the studs (N1).
5. Place the glass diuser (K1) onto the holder (J1),
secure it using the nuts (I1).
6. Secure the mounting plate (E1) to the junction box (F1)
using the junction box screws (A1). The side of the mounting
plate marked “GND” (E1) must face out.
CONNECTING THE WIRES (Fig. 2)
7. Connect the transformer input wire to supplier wires as shown in Fig.2, making
sure that all wire connectors (B1) secured. If your outlet box has a green or bare
copper ground wire, connect the xture’s ground wire to it. Otherwise, connect
the xture’s ground wire directly to the mounting plate (E1) using the green screw
provided. After wires are connected, tuck them carefully inside the junction box.
*Requires Transformer (H1) to be recessed within the junction box
8. Place the xture back plate (L1) over the mounting plate (E1) and secure with screws (E1).
9. Put the shade (M1) into the clips on the xture back plate (L1) well.
B1
E1H1
F1
A1
L1
C1
J1
G1
N1
K1
I1
M1
D1
FIG.1