Installation & Assembly

2
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company’s continuous improvement program.
INSTALLATION INSTRUCTION
928 – LED PENDANT
PD-92818
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the
parts on a clear area. Be careful not to lose any small
parts necessary for installation.
CONNECTING THE WIRES (Fig. 1)
3. Remove the mounting screw (C) from the xture.
4. Adjust the xture wire length by pushing the cable
gripper on the canopy and pulling the wire as desired.
5. Connect the driver input wires with junction box wires
as shown in Fig.2, making sure that all wire connectors
(A) are secured. If your outlet box has a green or bare
copper ground wire, connect the xture’s ground wire
to it. Otherwise, connect the xture’s ground wire
directly to the mounting plate using the green screw
provided. After wires are connected, tuck them carefully
inside the junction box
*Requires Driver to be recessed within the junction
box
MOUNTING THE FIXTURE (Fig. 2)
6. Secure mounting plate to the junction box using
junction box screws (B).The side of the mounting plate
marked “GND” must face out.
7. Connect the driver output wires with junction box wires
as shown in Fig.2, making sure that all wire connectors
(A) are secured.
8. Place the xture over the mounting plate and secure it
with mounting screws (C) .
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 1 Wiring
FIG. 2
BACK PLATE DIMENSIONS
G0
Junction Box
Wire Connector
Mounting Plate
Cable-gripper
Push Up
Fixture
Junction Box Screw
Mounting Screw
Ground Wire
Driver 2 7/8”[L]x1 3/8”[W]x1 1/8”[H]
A
B
C
d
k
a
1 3/4”
1 3/8”
Ø4 6/8”
7MBC120803