Installation & Assembly
//
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
('0120%&-3
3. Remove the mounting screw (B) from the canopy.
4. The lamp can switch between three color temperatures (2700k-3000k-3500k), which can be adjusted to your preference with the switch in
the canopy (Fig.3).
5. Secure the mounting back plate to the junction box using standard junction box screws that comes with the junction box.
Note: (i) using any other non-original-manufacturer provided junction box screw may result in safety issue;
(ii) The side of the mounting plate marked “GND” must face out.
')20%&+3
6. Connect the xture’s wires to junction box wires as shown (Fig. 2). Make sure that all wire connectors (A) are secure. If your outlet box
has a green or bare copper ground wire, connect the driver’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
back plate using screw provided. After wires are connected, tuck them carefully inside the junction box.
(/4')44
7. Secure the xture to the mounting back plate using the mounting screw (B).
05
Black or
Smooth
05
White or
Ribbed
05
Bare wire
(Ground)
Black
(Hot)
White
(Neutral)
Green or Bare Copper
(Ground)
0%&+%
2
INSTALLATION INSTRUCTIONS
+,-.")
WS-26111
Phone (800) 526.2588
Fax (800) 526.2585
44 Harbor Park Drive
Port Washington, NY 11050
1600 Distribution Ct
Lithia Springs, GA 30122
1750 Archibald Avenue
Ontario, CA 91760
WS-26111
Back Plate Dimensions
10
5
8
″
4
1
8
″
1
3
8
″
1
3
4
″
0%&-
3000K3500K
2700K
0%&6
Junction box
Mounting plate
Wire connector
Junction box screw
Mounting screw
Fabric shade
(RPL-SHA-26111)
A
B
Ground wire
Diuser
(RPL-DIF-26111)
Glass
(RPL-GLA-26111)