Installation & Assembly

Modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Ave
Ontario, CA 91761
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. Oct. 2019 2.,
INSTALLATION INSTRUCTIONS
820-LED Pendant
PD-82006
s
Fig.1 Fig. 2 Wiring
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (B) and back plate from the fixture.
4. Adjust the fixture wire length by pushing the cable-gripper on the canopy and pulling the wire as desired.
a. Retract the wires close to the desired length to within the canopy before securing the fixture in place. Using the cable-gripper to
adjust more than 18” of wire length is not recommended.
WARNING: Shortening the cables without professional help or electronic background is not advisable. Any modifications to the
fixture will result in voiding the warranty of the product.
5. Secure the driver to the mounting back plate using driver screw (D).
6. Secure the mounting back plate to the junction box using the screws that come with the junction box.
NOTE: The side of the mounting plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
7. Connect the driver’s input/output wires with supply/fixture wires as shown (Fig. 2). Make sure that all wire connectors (A) are
secure. If your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the mounting plate using the green screw provided. After wires are connected, tuck them carefully
inside the junction box.
COMPLETING THE INSTALLATION (Fig. 1)
8. Place the fixture over the mounting plate and secure it with mounting screws (B)
9. Thread the crystal into the fixture
1