Installation & Assembly

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
606- LED Outdoor
WS-W60610/WS-W60616
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screw (C1) from the canopy.
4. Secure the mounting plate to the junction box using junction box screws (B1).The side of the mounting back plate marked
“GND” must face out.
5. Connect the xture wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box
has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1)
6. Secure the canopy on the mounting plate with mounting screw (C1).
7. Thread the xture with glass on the canopy, secure it with Allen screw (D1) using Allen wrench (E1).
8. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of xture back plate where it meets the wall. Leave a space at the bottom to allow moisture to escape Fig. 3.
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
H
ouse Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
FIG.1
Back Plate Dimensions
G
N
D
A1
B1
D1
Wire
Connector
Junction Box Screw
Allen Screw
Junction Box
Mounting Plate
Fixture with Glass
Canopy
Ground Screw
E1
C1
Allen Wrench
Mounting Screw
1 3/4”
1 3/8”
Ø4”
Junction Box
Caulking
Fig. 3 Sealing