Installation & Assembly

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JUNE, 2015 2
INSTALLATION INSTRUCTION
Bloc - Wall Sconce
WS-W9201, WS-W9202
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Junction Box
Caulking
Fig.3 Sealing
PREPARATION
- Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
- Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
1. Remove the top and bottom mounting screws (C1) from the xture.
2. Secure mounting back plate to the Junction box using junction box screws (B1).
CONNECTING THE WIRES (FIG. 2)
3. Connect the supply wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box has a green or bare
copper ground wire, connect the xture’s ground wire to it. After wires are connected, tuck them carefully inside the junction box.
4. Place the xture over the mounting back plate and secure with mounting screws (C1) and gasket (D1).
COMPLETING THE INSTALLATION (FIG. 3)
5. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline
the outside of xture back plate where it meets the wall. Leave a space at bottom to allow moisture to escape.
Fig. 1
Junction Box Screw
Gasket
Junction BoxMounting Plate
Mounting Screw
Wire Connector
C1
D1
B1
A1
Fig. 2