Installation & Assembly

FIG 1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture, including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts
necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Connect the fixture input wires to junction box wires as shown (Fig. 2). Make sure that all wire connectors are secure.
If your outlet box has a ground wire (Green or bare copper), connect the fixture’s ground wire to it. After wires are
connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1)
4.
Remove the diffuser from the base plate by twisting it counter-
clockwise.
Discard the foam spacer and secure the base plate to the
junction box using the junction box screws provided.
6.
Reinstall the diffuser onto the base plate by twist locking in a
clockwise direction.
5.
3", 4" or 3/0-4/0 Junction Box
Wire Connector
Base Plate
Junction Box Screw
Diffuser
INSTALLATION INSTRUCTIONS
PUCK
FM-4514, FM-4516
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JAN 2019
2
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]