Owner Manual

9FR-W1810
6. INSTALLING THE MOUNTING BRACKET
REMEMBER to disconnect the power by removing fuses or turning o circuit breakers.
Follow the steps below to hang your fan properly:
1. Disconnect power to the fan location. A licensed electrician must
install the fan if required by your local electrical code (Fig. 5).
2. Remove 1 of 2 screws from the bottom of the mounting bracket
and loosen the other screws.
3. Pass the 120-volt supply wires through the center hole in the
ceiling mounting bracket as shown in Figure 7.
4. Secure the mounting bracket to the ceiling outlet box with the
screws and at washers provided (Fig. 7).
FIGURE 5
FIGURE 6
FIGURE 7
UL/cUL Listed
electrical box
Mounting
bracket
Mounting screws
120V wire
Mounting
bracket
Screw