Owner Manual

11FR-W1810

9. HANGING THE FAN

1. Remove the clevis pin and cotter pin and loosen the two collar

screws from the motor collar (Fig.11).

2. Feed motor wires through coupling cover, canopy ring, and

canopy

3. Feed motor wires through downrod assembly.

4. Thread the downrod assembly onto motor collar. Align the holes

of down- rod and collar and insert the cotter pin and clevis pin.

Tighten the two collar screws (Fig. 11).

WARNING: Failure to properly install the cotter pin and/or tighten the

screws could result in the fan loosening and possibly falling.

FIGURE 11

Clevis pin

Canopy Ring

Coupling Cover

Canopy

Cotter pin

Downrod Assembly