Installation & Assembly

2
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company’s continuous improvement program.
INSTALLATION INSTRUCTION
908– Pendant
PD-90830
PREPARATION
1. Shut o the power at the circuit breaker and remove existing
xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a
clear area. Be careful not to lose any small parts necessary for
installation.
CONNECTING THE WIRES Fig. 2
3. Remove the mounting screw (C) from the xture.
4. 4. Drill a hole in the wall aligned with the key holes located in the
mounting plate, insert the plastic anchor (D).
5. 5. Connect the transformer’s input wires to junction box wires
as shown in Fig. 2, making sure that all wire connectors (A) are
secured. If your outlet box has a green or bare copper ground
wire, connect the xture’s ground wire to it. Otherwise, connect
the xture’s ground wire directly to the back plate using the
green screw provided. After wires are connected, tuck them
carefully inside the junction box.
COMPLETING THE INSTALLATION (Fig. 1, 2 )
6. Secure the mounting back plate to the junction box using
junction box screws (B), fasten it to the wall using the wood
screw (E), The side of the mounting back plate marked “GND”
must face out.
7. Adjust the xture wire length by pushing the cable gripper on
the canopy and pulling the wire as desired.
8. Secure the xture onto the mounting back plate with mounting
screw (C).
Fig.1
Back Plate Dimensions
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
D
E
B
C
A
Ground Wire
Junction Box
Wire Connector
Location Lable
Transformer
2 1/8” L X 1 3/8” W X 1” H
Plastic Anchor
back plate
Cable-Gripper
Push Up
Fixture
Wood Screw
Junction Box
Screw
Mounting
Screw
15/8"
31/2"
87/8"
8 7/8”
1 5/8”
3 1/2”