Installation & Assembly

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. 2
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the
parts on a clear area. Be careful not to lose any small parts
necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screw (C) from the canopy.
4. Remove the nut (D) from the canopy.
5. Put the cable-gripper through decorative plates and
canopy, lock it with the nut (D).
6. Secure mounting back plate to the junction box using
junction box screws (B), The side of the mounting plate
marked “GND” must face out.
7. Adjust the xture wire length by pushing the cable gripper
on the canopy and pulling the wire as desired.
MOUNTING THE FIXTURE (Fig. 1)
8. Connect the ring’s wire to the bridge’s output wire which
marked to xture as shown in Fig 3. making sure that all
wire connectors(E) Ps: There are positive and negative pole.
9. Connect the bridge’s input wire which marked to
transformer as shown in Fig. 3 to transformers white wire,
making sure that all wire connectors (E).
10. Connect the transformer input wires with junction
box wires as Shown in Fig.2, making sure that all wire
connectors (A) are secured. If your outlet box has a green
or bare copper ground wire, connect the xture’s ground
wire to it. Otherwise, connect the xture’s ground wire
directly to the mounting plate using the green screw
provided. After wires are connected, tuck them carefully
inside the junction box.
11. Place the xture over the mounting back
plate and secure it with mounting screws (C) .
INSTALLATION INSTRUCTION
268-LED Pendant
PD-26801
Fig.1




Junction Box
To housewire
Bare copper wire
Nut
Wire Connector
Mounting backplate
Junction Box Screw
Mounting Screw
Canopy
4PEND-RN26801-TT/BK
Decorative Plates
(DP-RN26801-TT/BK)
Cable-gripper
Withdrawable
(Magnet)
Ring
(SOCKET 26801-TT/BK
A
B
C
C