Installation & Assembly

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
INSTALLATION INSTRUCTION
Drift
PD-58756
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out all the
parts on a clear area. Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (FIG.1)
3. Drill holes in the ceiling aligned with the key
hole location in the mounting plate (D1).
4. Insert the mounting anchors (B1) into holes.
5. Secure the mounting plate (D1) to the junction box (A1)
using junction box screws (E1). The side of the mounting
plate marked “GND” must face out.
6. Fasten the wood screws (F1) into the mounting
anchors (B1) and tighten.
7. Slide the glass (L1) into the xture (J1).
8. On each end of xture, angle-in the end caps (K1)
and press in to secure.
9. Adjust the xture wire length by pressing the
cable-grippers (I1) on canopy and pulling the wire.
Make sure the wires are the same length.
10. Re-set the strain relief (N1) near the wiring holes.
CONNECTING THE WIRES (FIG.2)
11. Connect the transformer input wires with supply wires
as shown in Fig. 2, making sure that all wire connectors
(C1) are secured.
12. Cut the xture wires and leaving at least 6”. Connect
with the transformer output wires red).
Note: The xture wires have two braided layers.
Strip the two layers carefully!
If your outlet box has a ground wire, connect it to the
xture’s ground wire. Otherwise, connect the xture’s
ground wire directly to the mounting plate (D1) using
the green screw provided. Tuck wires carefully inside the
junction box.
13. Place the canopy (G1) over the mounting plate (D1),
secure with screws (H1).
14. Check if xture is level and adjust cables if necessary.
A1
B1
C1
D1
E1
F1
N1
H1
G1
I1
J1
K1
K1
J1
L1
FIG.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
Supply wire
Transformer
Input
Output
Fixture wire