Installation & Assembly

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
167 - LED Outdoor
WS-W16728
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screws (C1) and gaskets (D1) from the xture.
4. Secure the mounting plate to the junction box using junction box screws (B1), the side of the mounting plate marked "GND" must face out.
5. Insert the crystal into the xture; secure it with Allen screws (F1) using Allen wrench (E1).
CONNECTING THE WIRES (Fig. 2)
6. Connect the xture wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box
has a green or bare copper ground wire, connect the xture's ground wire to it. Otherwise, connect the xture's ground wire directly to the
back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
7. Secure the xture to mounting plate with the mounting screws (C1) and gaskets (D1).
8. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of xture back plate where it meets the wall. Leave a space at the bottom to allow moisture to escape Fig. 3.
Allen Wrench
Allen Screw
Mounting Screw
Rubber Gasket
Wire
Connector
Junction Box Screw
Junction
Box
Mounting Plate
Back Plate Dimensions
Crystal
(RPL-GLA-16728-01)
Fixture
E1
F1
C1
D1
A1
B1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
FIG. 1
Junction Box
Caulking
Fig. 3 Sealing
1 3/8"
1 3/4"
5 5/8"
4 1/4"