Installation & Assembly

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the Allen screws (C1) using Allen wrench (F1), take down the lamp body.
4. Drill holes in the wall aligned with the key holes located in the mounting back plate, insert the plastic anchors (E1).
5. Connect the Driver's input wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured.
If your outlet box has a green or bare copper ground wire, connect the xture's ground wire to it. Otherwise, connect the xture's ground
wire directly to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
*Requires Driver to be recessed within the junction box
MOUNTING THE FIXTURE (Fig. 2)
6. Secure the mounting back plate to the junction box using junction box screws (B1), fasten it to the wall using wood screws (D1).
The side of the mounting back plate marked "GND" must face out.
7. Connect the driver's output wires to the xture as shown in Fig. 2, making sure that all wire connectors are secured.
8. Secure the lamp body onto mounting back plate with Allen screws (C1) using Allen wrench (F1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Wire
Connector
Plastic
Anchor
Junction
Box Screw
Wood
Screw
Allen
Wrench
Allen
Screw
Lamp Body
Mounting
Back Plate
Junction Box
Back Plate Dimensions
Driver
A1
E1
B1
D1
F1
C1
FIG. 1
INSTALLATION INSTRUCTION
737 - LED Flush Mount
FM-73710, FM-73714
FM-73710: 9 3/4"
FM-73714: 6 1/4"
1
3/8"
1 3/4"
FM-73710: 9 3/4"
FM-73714: 13 1/4"
FM-73710: 7"
FM-73714: 10 7/8"