Installation & Assembly

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screws (C1) from the xture.
4. Connect the driver input wires with supply wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box
has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
mounting plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
*Requires Driver to be recessed within the junction box.
MOUNTING THE FIXTURES (Fig. 1)
5. Secure mounting back plate to the junction box using junction box screws (B1). The side of the mounting plate marked “GND” must face
out. Pull out the driver output wire.
6. Choose the number of down rods suitable of your application.
7. Thread the xture wire through the rods and canopy.
Connect the canopy, down rod and xture body. Make sure all are tightened.
8. Connect the driver output wires with xture wire as shown in Fig. 2,
making sure that all wire connectors ( A1) are secured.
9. Place the xture over the mounting back plate and secure it with
mounting screws (C1).
10. Adjust the connection tubes to your desired angle, fasten it with
Allen screws (E1) using Allen wrench (D1).
11. Thread the glass into the lamp holder.
Wire Connector
Junction Box Screw
Mounting Screw
Allen Wrench
Allen Screw
Lamp Body
Connection Tube
Lamp Holder
Glass
(RPL-GLA-53728-01)
Canopy
Down Rod
Junction Box
Driver
Mounting Back Plate
A1
B1
C1
D1
E1
FIG. 1
INSTALLATION INSTRUCTION
537 - LED Pendant
PD-53751
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Ø 4 3/4"
Back Plate Dimensions
1 3/4"
1 3/8"